Fukuda Denshi DSL-8001, Руководство по эксплуатации

Страница: 26 / 252

xxiv
Precautions about the Ventilator Monitoring
WARNING
 The ventilator alarm on this monitor should be used as
supplementary function. Check the patient's condition,
ventilator alarm sound and message occasionally.
 If the DSL-8001 system does not generate an alarm even
though the ventilator is generating an alarm, or if any other
malfunction occurs, immediately check the ventilator,
DSL-8001 system, cable, and replace the cable if necessary. If
the malfunction persists, stop using the equipment.
 If [OFF] is set for the COM port which the ventilator is
connected, the ventilator message will not be displayed and
ventilator alarm sound will not be generated. Make sure the
correct setting is made.
 When [OFF] is set for “VENT Alarm”, the <Vent. Alarm> will
not be displayed in the alarm message area even if a ventilator
alarm is generated.
 The alarm generation on the Servo-i is not assured if the alarm
other than the following generates at the ventilator.
 Servo-i
airway pressure upper limit alarm, high continuous
pressure alarm, O
2
concentration lower limit alarm,
expiratory minute volume upper/lower limit alarm, apnea
alarm, gas supply alarm, air supply alarm, O
2
supply alarm,
battery alarm, no battery alarm, limited battery alarm,
overrange alarm, expiratory cassette disconnected alarm,
backup ventilation alarm, regulation pressure limited
alarm, respiratory rate alarm, PEEP low alarm, EtCO
2
upper limit alarm, EtCO
2
lower limit alarm
 Servo-s
airway pressure upper limit alarm, high continuous
pressure alarm, O
2
concentration lower limit alarm,
expiratory minute volume upper/lower limit alarm, apnea
alarm, gas supply alarm, air supply alarm, O
2
supply alarm,
backup ventilation alarm, respiratory rate alarm, PEEP low
alarm