Fukuda Denshi DSL-8001, Руководство по эксплуатации

Страница: 212 / 252

8 － 30
The measurement data is displayed as “xxx”.
Cause : The temperature measurement is outside the measurement range.
Solution :
・
Check if the temperature probe is properly inserted.
・
Replace the temperature probe, or check the temperature
probe.
Alarm
Alarm is not generated. Alarm message is not displayed.
Cause 1 : Alarm is silenced.
Solution : The alarm sound will automatically resume after the preprogrammed
alarm silence duration. To cancel the alarm silence condition, press
the
(Alarm Silence) key again.
Cause 2 : Alarm sound is suspended.
Solution : Pressing the
(Alarm Silence) key for 3 seconds or more will
suspend the alarm sound in advance for preprogrammed duration.
<Alarm Silence (xx min.)> message will be displayed during this
condition. To cancel the alarm sound suspend condition, press
again the
(Alarm Silence) key for 3 seconds or more.
Memo For the parameters in alarm OFF condition, the " " (Alarm OFF)
icon will be displayed inside the corresponding numeric data box
Cause 3 : The alarm limit is not set.
Solution : Set the upper/lower alarm limit for each parameter.
Printer
No printing is performed. The <Paper Out> message is displayed.
Cause : There is no recording paper.
Solution : Install a new roll of paper into the paper cassette.
The <No Printer Installed> message is displayed.
Cause : [Built-in] is set for the “Output Printer” although the DSL-8001 is not
equipped with a built-in printer.
Solution : Select [Center] for the “Output Printer” of “Manual Printing”, “Alarm
Printing”, “Periodic Printing”.
For manual printing, press the (Menu) key, select “Printing Setup” >
“Manual Printing Setup”, and select [Center] for “Output Printer”.
For alarm printing, press the (Menu) key, select “Printing Setup” >
“Alarm Printing Setup”, and select [Center] for “Output Printer”.
For periodic printing, press the (Menu) key, select “Printing Setup” >
“Periodic Printing Setup”, and select [Center] for “Output Printer”.