Fukuda Denshi DSL-8001, Руководство по эксплуатации

Страница: 168 / 252

7 － 2
Precautions for Installing the Equipment
This section describes the environmental condition to use the DSL-8001.
CAUTION
The installation of this equipment should be performed by our
service representative or a person who is well acquainted with
this equipment.
Precautions about the Operating Environment
 The following environmental conditions should be observed when operating the
equipment.
・
Surrounding Temperature: 5 to 40  C
・
Relative Humidity: 30 to 85% (non-condensing)
・
Atmospheric Pressure : 700 to 1060hPa
 The DSL-8001 is intended for patient monitoring in ICU, CCU, surgery, ER and
general wards. Direct use in MRI environment or home-care should be
prohibited.

The power source should fulfill the following condition.
・
Verify power voltage and frequency before connecting to an AC power
source.
・
Use the power source that can provide adequate power to the device.
 Pay attention when installing or storing the equipment. Do not install or store in
the following locations.
・
where chemicals are stored or gas may evolved.
・
where the equipment will be subject to splashing water or humidity from
a nebulizer or vaporizer
・
where the equipment will be subject to direct sunlight
・
unstable place with inclination, vibration, or shock.
 Ensure proper ventilation to cool the device.
・
A minimum space of 5 cm is required between vents on the rear side of
the monitor and the wall. If the monitor is embedded in a wall or
surrounded by a wall, a minimum space of 10 cm is required.
 This equipment must be placed on a level surface. If installed in incorrect
direction, water or chemicals may enter the equipment and cause damage.
This may also cause paper jam in the printer unit.
WARNING
If the equipment is used under an environment not fulfilling the
specified condition, not only that the equipment cannot deliver
its maximum performance, the equipment may be damaged and
safety cannot be ensured.
If using in an environment other than specified above, contact
our service representative.