Fukuda Denshi DSL-8001, Руководство по эксплуатации

Страница: 83 / 252

2 － 33
Ventilator Alarm Input
By connecting a ventilator (Servo-i/Servo-s) to the serial connector
(COM1/COM2) of this unit, ventilator alarm and the connection status alarm will
be generated.
Also, ventilator alarm can be notified to the central monitor via wireless network.
Reference
For details, refer to “7. Installation/Ventilator Connection”.
WARNING
 The ventilator alarm on this unit should be used as
supplementary function. Check the patient's condition,
ventilator alarm sound and message occasionally.

If the DSL-8001 system does not generate an alarm even
though the ventilator is generating an alarm, or if any other
malfunction occurs, immediately check the ventilator,
DSL-8001 system, cable, and replace the cable if
necessary. If the malfunction persists, stop using the
equipment.
 The alarm generation on the DSL-8001 system is not
assured if the alarm other than the following generates at
the ventilator.
 Servo-i
airway pressure upper limit alarm, high continuous
pressure alarm, O
2
concentration lower limit alarm,
expiratory minute volume upper/lower limit alarm, apnea
alarm, gas supply alarm, air supply alarm, O
2
supply alarm,
battery alarm, limited battery alarm, no battery alarm,
overrange alarm, expiratory cassette disconnected alarm,
backup ventilation alarm, regulation pressure limited alarm,
respiratory rate alarm, PEEP low alarm, EtCO
2
upper limit
alarm, EtCO
2
lower limit alarm
 Servo-s
airway pressure upper limit alarm, high continuous
pressure alarm, O
2
concentration lower limit alarm,
expiratory minute volume upper/lower limit alarm, apnea
alarm, gas supply alarm, air supply alarm, O
2
supply alarm,
backup ventilation alarm, respiratory rate alarm, PEEP low
alarm
Ventilator Icon