INSTRUCTIONS
FIELD-ADJUSTABLE SR™ INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
Fig: 3
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Disconnect or turn OFF power at the electrical panel before installing or maintaining fi xture. No User serviceable
parts inside fi xture.
Suitable for damp locations. Suitable for operation in ambient not exceeding 50°C.
SURFACE MOUNTING
The fi xture is suitable for indoor ceiling mounting, as follows:
1.
Press and hold the
Release Buttons
(4)
on both sides of the
Fixture Housing
to release the
Lens
(Fig. 1)
. When pressing the
Release Buttons
use one hand to hold the
Lens
and press the
Release Buttons
on both sides of the
Fixture
with the other hand.
CAUTION: The Lens may drop out quickly. Lens
is supported
with
(2)
Tether Cables
(Fig. 3).
2.
Attach both
Junction Box Cover Plates
to the
Fixture Housing
by
sliding in the direction of arrows as shown in Fig. 2. Secure with
(2)
Screws
(provided)
.
3. Feed supply wires through
Wire Access Hole
. Secure
Fixture
Housing
to the junction box or building structure per NEC
Code
(Fig. 3)
.
4.
Make electrical connections as shown in wiring diagram
(Fig. 12)
. Use approved wiring connectors and wire to local NEC
codes. Push all wires back into
Fixture Housing
. Be careful not to
pinch wires.
5.
Snap
Lens
back into
Fixture Housing
and remove protective
plastic from
Lens
.
WARNING: To prevent wiring damage or abrasion, do not expose
wiring to sharp objects.
Lens
Release Buttons
(4)
Fixture Housing
Screws
(4)
Junction Box
Cover Plates
Tether Cables
(2)
Wire Access Hole
Fixture Housing
Lens
SR2
SR4
SR8
Fig: 2
Fig: 1
Screws
(2)
