Dinli DL-702 2008, Руководство по обслуживанию

Страница: 46 / 306

【
3-16
】
BRAKE
Rear Disc Installation
●
The disc must be installed with the marked side [B] facing toward
front.
● Apply non
-permanent locking agent: Disc Mounting Bolts.
● Tighten the disc mounting bolts to the specified torque.
Tightening Torque: 25 N-m (2.5 kg-m, 18.0 lb-ft)
●
After installing the discs, check the disc runout (see Disc Runout).
Completely clean off any grease that has gotten on either side of
the disc with a high flash point solvent.
Inspection
Disc Wear
● Measure the thickness
of each disc at the point [A] where it has
worn the most.
★ Replace the disc if has worn past the service limit.
[B] Measuring Area
Micrometer (0 – 25 mm)
Disc Runout
● Jack up the vehicle so that the wheels are off the ground.
● Remove th
e front wheels and turn the handlebar fully to one side.
● Set up a dial gauge against the disc [A], and measure the disc
runout.
★ If the runout exceeds the service limit, replace the disc.
Dial gauge (1/100 mm)
Magnetic stand
A
B
A
B
Front Disc Thickness
Service Limit 3 mm
Rear Disc Thickness
Service Limit 3.5 mm
Disc Runout
Service Limit 0.3 mm