Dinli DL-702 2008, Руководство по обслуживанию

Страница: 160 / 306

【
6-50
】
ENGINE
Gearshift Fork
Visual checking – Shift Fork and Drum
● Check for ware and damage.
● If any wear on the Fork craw portion, replace with new one.
Visual checking – Main Shaft and Counter Shaft Assy.
● After disassembling, check for wear and damage on dig clutch
portion, gears and spline portions.
● If any wear and damage had found, replace with new one.
Gearshift Fork ‐ To ‐ Groove Clearance
● Measure the gear fork ‐ to ‐ groove clearance by using the thickness
gauge.
● If the clearance exceeds the limits, replace the fork or its gear, or
both.
Shift for to groove clearance
Standard 0.10 – 0.27 mm
Service Limit 0.50 mm
Thickness Gauge
Width of Shift Fork Groove
● Check for wear and scratch in the Fork groove.
● Measure the width of shift fork groove with vernier calipers .
Width of Shift Fork groove
Reverse 5.60 ‐ 5.67 mm
Standard
High 5.60 ‐ 5.67 mm
Vernier Calipers
Thickness of Shift Fork
● Measure the thickness of Shift Fork with micrometer.
Thickness of Shift Fork
Reverse 5.40 ‐ 5.50 mm
Standard
High 5.40 ‐ 5.50 mm
Vernier Calipers