Dinli DL-702 2008, Руководство по обслуживанию

Страница: 210 / 306

【
7-7
】
ELECTRICAL SYSTEM
○
Troubles may involve one or in some cases all items. Never
replace a defective part without determining what CAUSED the
failure. If the failure was caused by some other item or items,
they too must be repaired or replaced, or the new replacement
will soon fail again.
○
Make sure all connectors in the circuit are clean and tight, and
examine wires for signs of burning, fraying, etc. poor wires and
bad connections will affect electrical system operation.
○
Measure coil and winding resistance when the part is cold (at
room temperature).
○
Be careful not to drop the part with a semi ‐ conductor built in
such as a CDI unit.
○
Properly use the multi ‐ circuit tester
(＋
) and
(－)
probes.
Improper use can cause damage to the vehicle and tester.
○
If the voltage and current values are not known, begin measuring
in the highest range.
○
When measuring the resistance, make sure that no voltage is
applied. If voltage is applied, the tester will be damaged.
○
After using the tester, be sure to turn the switch to the OFF
position.
Multi ‐ Circuit Tester Set
○
Color codes:
○
Electrical Connectors:
Female Connectors [A]
Male Connectors [B]
B Black G Green P Pink
Bu Blue Gr Gray Pu Purple
Br Brown LB Light blue R Red
Ch Chocolate LG Light green W White
DG Dark green O Orange Y Yellow
CAUTION
Before using the multi ‐ circuit tester, read its instruction
manual.