Dinli DL-702 2008, Руководство по обслуживанию

Страница: 231 / 306

【
7-28
】
ELECTRICAL SYSTEM
Fuel Gauge
● Measure the resistance at each fuel level gauge float position. If
the resistance is incorrect, replace the carburetor with a new one.
E: 5 mm
Multi ‐ Circuit Tester Set
Tester knob indication: Resistance
(Ω
)
Speedometer
● If the speedometer, odometer or trip meter does not function
properly, inspect the speed sensor and connection of coupler.
● If the speed sensor and connection are functioning properly,
replace the speedometer with a new one.
● Remove the left mud guard.
● Disconnect speed sensor coupler [1].
● Remove the speed sensor [2] by removing its mounting bolt.
● Connect the 12 V battery, 10k Ω resistor and the multi ‐ circuit
tester as shown in the right illustration.
Multi ‐ Circuit Tester Set
Tester knob indication: Voltage (DCV)
● Under above condition, if a suitable screwdriver touching the
pick ‐ up surface of the speed sensor is moved, the tester reading
voltage changes (0 V to 12 V or 12V to 0V). If the tester reading
voltage does not change, replace the speed sensor with a new
one.
NOTE
The highest voltage reading in this test will be the same as
that of battery (12 V).
Float position Resistance
F: 123 mm
“F” (Full) Approx. 10 Ω
“E” (Empty) Approx. 90 Ω
1
2