Dinli DL-702 2008, Руководство по обслуживанию

Страница: 251 / 306

【
9-13
】
PERIODIC MAINTENANCE
Carburetor Limiting Device
Engine Oil and Oil Filter
●
The oil should be changed while the engine is warm. Oil filter
replacement at the above intervals should be done together with
the engine oil change.
Engine Oil Replacement
●
Place an oil pan under the drain plug [1], and then drain out the
engine oil by removing the engine oil drain plug [1] and engine
oil filler cap [2].
●
Tighten the drain plug, with the new washer, to the specified
torque, and then pour the new oil through the oil filler hole.
Tightening Torque: 19 N-m (1.9 kgf-m, 14.0 lb-ft)
●
When performing an oil change, the engine will hold about 3.3 L
of oil. Use engine oil that meets the API service classifications SF
or SG and that has a viscosity rating of SAE 10W/40.
●
Tighten the oil filler cap [2].
●
Start the engine and allow it to run for a few minutes at idling
speed.
●
Turn off the engine and wait about three minutes, and then check
the oil level on the dipstick [3]. If the level is below upper line,
add oil to that level. The vehicle must be placed on level ground
for accurate measurement.
Replace initially at 200 km (10 hours, 1 month) and every
2000 km (100 hours, 6 months) thereafter.
CAUTION
The carburetor has a limiting device which has limit the
horsepower of the engine to prevent damage.
1
2
3
H
L
N