permit udp
To pass UDP packets meeting the filter criteria, configure a filter.
Syntax
permit udp {
source mask
| any | host
ip-address
} [
operator port
[
port
]] {
destination mask
| any | host
ip-address
} [dscp]
[
operator port
[
port
]] [count [byte]] [order] [fragments] [log
[interval
minutes
] [threshold-in-msgs [
count
]] [monitor]
To remove this filter, you have two choices:
• Use the
no seq
sequence-number
command if you know the filter’s
sequence number.
• Use the
no permit udp {
source mask
| any | host
ip-address
}
{
destination mask
| any | host
ip-address
command.
Parameters
source
Enter the IP address of the network or host from which the
packets were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
any
Enter the keyword
any
to specify that all routes are subject
to the filter.
host
ip-address
Enter the keyword
host
and then enter the IP address to
specify a host IP address.
dscp
Enter the keyword
dscp
to deny a packet based on the
DSCP value. The range is from 0 to 63.
operator
(OPTIONAL) Enter one of the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the
port
parameter)
port port
Enter the application layer port number. Enter two port
numbers if you are using the
range
logical operand. The
range is 0 to 65535.
destination
Enter the IP address of the network or host to which the
packets are sent.
count
(OPTIONAL) Enter the keyword
count
to count packets
processed by the filter.
byte
(OPTIONAL) Enter the keyword
byte
to count bytes
processed by the filter.
order
(OPTIONAL) Enter the keyword
order
to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
Access Control Lists (ACL)
245
