•
ieee-v2
: configures the port to use IEEE 802.1az (Draft
2.5).
Defaults
Auto
Command
Modes
INTERFACE PROTOCOL LLDP
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBX debugging, use the
no debug dcbx
command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv}
Enter the type of debugging, where:
•
all
: enables all DCBX debugging operations.
•
auto-detect-timer
: enables traces for DCBX auto-
detect timers.
•
config-exchng
: enables traces for DCBX configuration
exchanges.
•
fail
: enables traces for DCBX failures.
•
mgmt
: enables traces for DCBX management frames.
•
resource
: enables traces for DCBX system resource
frames.
•
sem
: enables traces for the DCBX state machine.
•
tlv
: enables traces for DCBX TLVs.
Defaults
none
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
1432
PMUX Mode of the MXL 10/40GbE Switch I/O Module
