bgp client-to-client reflection
Allows you to enable route reflection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the
no bgp client-to-client
reflection
command.
Defaults
Enabled when a route reflector is configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Route reflection to clients is not necessary if all client routers are fully meshed.
Related
Commands
bgp cluster-id
— assigns an ID to a BGP cluster with two or more route reflectors.
neighbor route-reflector-client
— configures a route reflector and clients.
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reflector.
Syntax
bgp cluster-id {
ip-address
|
number
}
To delete a cluster ID, use the
no bgp cluster-id {
ip-address
|
number
}
command.
Parameters
ip-address
Enter an IP address as the route reflector cluster ID.
number
Enter a route reflector cluster ID as a number from 1 to
4294967295.
Defaults
Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When a BGP cluster contains only one route reflector, the cluster ID is the route
reflector’s router ID. For redundancy, a BGP cluster may contain two or more route
reflectors. Assign a cluster ID with the
bgp cluster-id
command. Without a
cluster ID, the route reflector cannot recognize route updates from the other route
reflectors within the cluster.
Border Gateway Protocol IPv4 (BGPv4)
317
