ospfv3
Specify that this ACL is for OSPFv3 control plane traffic
Defaults
All access lists contain an implicit “deny any”; that is, if no match occurs, the packet
is dropped.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0)
Added support for CoPP for OSPFv3 on the MXL 10/40GbE
Switch IO Module.
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The number of entries allowed per ACL is hardware-dependent. For detailed
specification on entries allowed per ACL, refer to your line card documentation.
You can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in
addition to the CoPP support for VRRP, BGP, and ICMP that existed in Dell
Networking OS releases 9.3(0.0) and earlier
Related
Commands
show config
— views the current configuration.
ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Syntax
ipv6 control-plane egress-filter
Defaults
Not enabled.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
permit
To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or
UDP.
Syntax
permit {
ipv6-protocol-number
| icmp | ipv6 | tcp | udp} [count
[byte]] [dscp
value
] [order] [fragments] [log [interval
minutes
] [threshold-in-
msgs
[count]] [monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command syntax if you know the filter’s
sequence number
IPv6 Access Control Lists (IPv6 ACLs)
667
