Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Enable spanning tree group 0 prior to using this command.
The following describes the
show spanning-tree 0
command shown in the
example.
Field
Description
“Bridge
Identifier...”
Lists the bridge priority and the MAC address for this STP
bridge.
“Configured
hello...”
Displays the settings for hello time, max age, and forward
delay.
“We are...”
States whether this bridge is the root bridge for the STG.
“Current root...”
Lists the bridge priority and MAC address for the root bridge.
“Topology flag...”
States whether the topology flag and the detected flag were
set.
“Number of...”
Displays the number of topology changes, the time of the
last topology change, and on what interface the topology
change occurred.
“Timers”
Lists the values for the following bridge timers: hold time,
topology change, hello time, max age, and forward delay.
“Times”
List the number of seconds since the last:
• hello time
• topology change
• notification
• aging
“Port 1...”
Displays the Interface type slot/port information and the
status of the interface (Disabled or Enabled).
“Port path...”
Displays the path cost, priority, and identifier for the
interface.
“Designated
root...”
Displays the priority and MAC address of the root bridge of
the STG that the interface belongs.
“Designated
port...”
Displays the designated port ID.
Example
Dell#show spann 0
Executing IEEE compatible Spanning Tree Protocol
Bridge Identifier has priority 32768, Address 0001.e800.0a56
Configured hello time 2, max age 20, forward delay 15
We are the root of the spanning tree
1276
Spanning Tree Protocol (STP)
