Key
Description
l
Change the view to the next interface on the line card, or if
in line card mode, the next line card in the chassis.
a
Change the view to the previous interface on the line card,
or if in line card mode, the previous line card in the chassis.
T
Increase the screen refresh rate.
t
Decrease the screen refresh rate.
q
Return to the CLI prompt.
Example (Single
Interface)
systest-3 Monitor time: 00:00:06 Refresh Intvl.: 2s Time:
03:26:26
Interface: Gi 0/3, Enabled, Link is Up, Linespeed is 1000 Mbit
Traffic statistics: Current Rate Delta
Input bytes: 9069828 43 Bps 86
Output bytes: 606915800 43 Bps 86
Input packets: 54001 0 pps 1
Output packets: 9401589 0 pps 1
64B packets: 67 0 pps 0
Over 64B packets: 49166 0 pps 1
Over 127B packets: 350 0 pps 0
Over 255B packets: 1351 0 pps 0
Over 511B packets: 286 0 pps 0
Over 1023B packets: 2781 0 pps 0
Error statistics:
Input underruns: 0 0 pps 0
Input giants: 0 0 pps 0
Input throttles: 0 0 pps 0
Input CRC: 0 0 pps 0
Input IP checksum: 0 0 pps 0
Input overrun: 0 0 pps 0
Output underruns: 0 0 pps 0
Output throttles: 0 0 pps 0
m - Change mode c - Clear screen
l - Page up a - Page down
T - Increase refresh interval t - Decrease refresh interval
q - Quit
mtu
Set the link maximum transmission unit (MTU) (frame size) for an Ethernet interface.
Syntax
mtu
value
To return to the default MTU value, use the
no mtu
command.
Parameters
value
Enter a maximum frame size in bytes. The range is from 594
to 9252. MXL Switch Range is from 594 to 12000. The
default is
1554
.
572
Interfaces
