track
Monitor an interface and lower the priority value of the VRRP group on that interface if it is disabled.
Syntax
track
interface
[priority-cost
cost
]
To disable monitoring, use the
no track interface
command.
Parameters
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Loopback interface, enter the keyword
loopback
then a number from 0 to 16383.
• For Port Channel interface types, enter the keywords
port-channel
then the number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a VLAN interface, enter the keyword
vlan
then the
VLAN ID. The VLAN ID range is from 1 to 4094.
cost
(OPTIONAL) Enter a number as the amount to be subtracted
from the priority value. The range is 1 to 254. The default is
10
.
Defaults
cost =
10
Command
Modes
VRRP
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If the interface is disabled, the cost value is subtracted from the priority value and
forces a new MASTER election if the priority value is lower than the priority value in
the BACKUP virtual routers.
virtual-address
Configure up to 12 IP addresses of virtual routers in the VRRP group. To start sending VRRP packets, set at
least one virtual address for the VRRP group.
Syntax
virtual-address
ip-address1
[
... ip-address12
]
To delete one or more virtual IP addresses, use the
no virtual-address
ip-
address1
[
... ip-address12
]
command.
Parameters
ip-address1
Enter an IP address of the virtual router in dotted decimal
format. The IP address must be on the same subnet as the
interface’s primary IP address.
1354
Virtual Router Redundancy Protocol (VRRP)
