For passive eBGP limits, the Remote AS must be different from the AS for this
neighbor.
Related
Commands
neighbor soft-reconfiguration inbound
— assigns a subnet to a dynamically
configured BGP neighbor.
neighbor remote-as
— assigns an indirectly connected AS to a neighbor or peer
group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {
ip-address
|
peer-group-name
} remote-as
number
To delete a remote AS entry, use the
no neighbor {
ip-address
|
peer-
group-name
} remote-as
number
command.
Parameters
ip-address
Enter the IP address of the neighbor to enter the remote AS
in its routing table.
peer-group-
name
Enter the name of the peer group to enter the remote AS
into routing tables of all routers within the peer group.
number
Enter a number of the AS. The range is from 0 to 65535 (2
byte) or from 1 to 4294967295 (4 byte).
Defaults
Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To accept 4-byte formats before entering a 4 byte AS Number, configure your
system. If the
number
parameter is the same as the AS number used in the
router
bgp
command, the remote AS entry in the neighbor is considered an internal BGP
peer entry.
This command creates a peer and the newly created peer is disabled (Shutdown).
Related
Commands
router bgp
— enters ROUTER BGP mode and configures routes in an AS.
bgp four-octet-as-support
— enables 4-byte support for the BGP process.
350
Border Gateway Protocol IPv4 (BGPv4)
