• 10 Gigabit Ethernet:
tengigabitethernet {
slot/
port
|
slot/port-range
}
• 40 Gigabit Ethernet:
fortygigabitethernet {
slot/
port
|
slot/port-range
}
• Port channel:
port-channel {
1-512
|
port-
channel-range
}
Where
port-range
and
port-channel-range
specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
gigabitethernet 1/1-2,5,9,11-12 port-channel
1-3,5
. A comma is required to separate each port and port-
range entry.
Defaults
none
Command
Modes
UPLINK-STATE-GROUP
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. Configure each
interface assigned to an uplink-state group as either an upstream or downstream
interface, but not both.
You can assign individual member ports of a port channel to the group. An uplink-
state group can contain either the member ports of a port channel or the port
channel itself, but not both.
Example
Dell(conf-uplink-state-group-16)# upstream gigabitethernet
1/10-15
Dell(conf-uplink-state-group-16)#
Related
Commands
•
downstream
— assigns a port or port-channel to the uplink-state group as a
downstream interface.
•
upstream
— assigns a port or port-channel to the uplink-state group as an
upstream interface.
•
uplink-state-group
— creates an uplink-state group and enables the tracking of
upstream links.
Uplink Failure Detection (UFD)
1321
