Parameters
config-source |
auto-
downstream |
auto-upstream
| manual
Enter the DCBX port role, where:
•
config-source
: configures the port to serve as the
configuration source on the switch.
•
auto-upstream
: configures the port to receive a peer
configuration. The configuration source is elected from
auto-upstream ports.
•
auto-downstream
: configures the port to accept the
internally propagated DCB configuration from a
configuration source.
•
manual
: configures the port to operate only on
administer-configured DCB parameters. The port does
not accept a DCB configuration received form a peer or a
local configuration source.
Defaults
Manual
Command
Modes
INTERFACE PROTOCOL LLDP
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
dcbx version
Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the
dcbx version {auto | cee | cin |
ieee-v2.5}
command.
Parameters
auto | cee | cin
| ieee-v2.5
Enter the DCBX version type used on the interface, where:
•
auto
: configures the port to operate using the DCBX
version received from a peer.
•
cee
: configures the port to use CDD (Intel 1.01).
•
cin
: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
426
Data Center Bridging (DCB)
