Parameters
interface
Enter one of the following interface types:
• Fast Ethernet:
fastethernet {
slot/port
|
slot/
port-range
}
• 1 Gigabit Ethernet:
gigabitethernet {
slot/port
|
slot/port-range
}
• 10 Gigabit Ethernet:
tengigabitethernet {
slot/
port
|
slot/port-range
}
• Port channel:
port-channel {
1-512
|
port-
channel-range
}
Where
port-range
and
port-channel-range
specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
gigabitethernet 1/1-2,5,9,11-12 port-channel
1-3,5
. A comma is required to separate each port and port-
range entry.
Defaults
none
Command
Modes
UPLINK-STATE-GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.4.2.3
Introduced on the S-Series S50.
Usage
Information
You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. Configure each
interface assigned to an uplink-state group as either an upstream or downstream
interface, but not both.
You can assign individual member ports of a port channel to the group. An uplink-
state group can contain either the member ports of a port channel or the port
channel itself, but not both.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1523
