Single-hub Network
893-743-A
3-7
Figure 3-6. Connecting a 10BASE-T interface card
2.
Connect the other end to the RJ-45 connector of the wall outlet (see
Figure 3-6).
Repeat steps 1 and 2 for each type of station until all Ethernet stations are
connected to the UTP horizontal distribution cabling through the RJ-45
connectors of wall outlets.
Cable Connections in the Wiring Closet
To complete the connection of each Ethernet station to a 10BASE-T host port
on the Model 281xSA hub, follow these steps:
1.
Verify that the total UTP segment length (including building wires
and all patch cables used on any run between the station and the hub)
does not exceed 100 meters.
NOTE:
To connect Ethernet stations to IBM Type 1 STP cable, use the Model
822 10BASE-T-to-Type 1 Adapter. See the Model 822 10BASE-T-to-Type 1
Adapter Reference Sheet for installation details.
2013.10.4.2