Configuring the Model 281xSA Hub for IP/IPX Networks
4-44
893-743-A
Boot Parameters Menu
When you select the b command [Set boot parameters] from the run-time
parameters menu, the menu in Figure 4-26 is displayed.
Figure 4-26. Boot Parameters menu
This menu includes the following commands:
m
[Toggle boot mode] Shifts the boot mode between Network and
NVRAM. The factory default setting is Network.
When Network is selected, the Model 281xSA hub tries to acquire
its configuration over the network, using the protocol specified by
the p command [Toggle boot protocol].
Boot Parameters Menu
4777.1
Local Image Status:
Boot Mode:
Boot Protocol:
Image Load Mode:
Config Load mode:
Boot Router IP Address:
Boot Server IP Address:
Image File Name:
Config File Name:
On-Board Version 1.0.0
Use EEPROM (Use NETWORK)
Auto (IP, IPX, IP_IPX)
REMOTE (LOCAL) (REMOTE w/LOCAL)
REMOTE (LOCAL) (REMOTE w/LOCAL)
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
c:\comm\281xSA.img
C:\COMM\281XSA.CFG
m
p
t
c
b
s
i
f
-
-
-
-
-
-
-
-
-ESC
Enter command:
Toggle boot mode
Toggle boot protocol
Toggle image load mode
Toggle config load mode
Set boot router's IP address
Set boot server's IP address
Set image file name
Set config file name
Return to main menu