Setting the Boot Configuration without a BootP Server
893-743-A
4-9
To set the boot configuration, follow these steps:
1.
Connect a terminal to the hub service port, as described in
“Connecting to the Model 281xSA Service Port” earlier in this
chapter.
2.
Turn on the power to the Model 281xSA hub; if it is already powered,
press the Reset button on the front panel.
3.
Press [Ctrl]+C while the hub is attempting its boot processes and the
screen reads “DCE#1 trying BOOTP...” This allows you to access the
Boot main menu (shown in Figure 4-4)
.
Figure 4-4. Boot main menu
4.
Set the hub IP network address, as follows:
a. Press j to display the IP Configuration menu.
b. Press i to display the Set IP Address prompt.
c. Enter the Model 281xSA hub IP address.
Boot Main Menu
281xSA Ethernet NMM
4756
MAC Address: 00:00:81:xx:xx:xx
Boot Mode:
Boot Protocol:
Management Protocol:
Network
Auto
IP_IPX
m
p
t
i
f
k
z
-Toggle boot mode
-Toggle boot protocol
-Toggle management protocol
-Toggle image load mode
-Toggle config file load mode
-Reset NVRAM to factory defaults
-Reset management module
c
b
j
x
e
g
w
|
|
|
|
|
|
|
-System configuration menu
-Boot file configuration menu
-IP configuration menu
-IPX configuration menu
-Load and execute boot files
-Perform power-up boot load sequence
-Write boot config to NVRAM
Image Load Mode: Remote w/local
Config Load Mode: Remote w/local