Setting Up the Model 281xSA Hub Configuration File
G-10
893-743-A
default-router ip_address
The address of the primary default router for this Model 281xSA hub—up
to 12 numeric characters in typical IP dotted-decimal notation. To cancel
this address, use 0.0.0.0. If no entry exists in the configuration file, the
default is none.
secondary-default-router ip_address
The address of the secondary default router for this Model 281xSA hub—
up to 12 numeric characters in typical IP dotted-decimal notation. To
cancel this address, use 0.0.0.0. If no entry exists in the configuration file,
the default is none.
boot router ip_address
The address of the router for this hub’s TFTP request.
ping router on|off
Enables or disables the ability of the Model 281xSA hub to issue an
Internet Control Message Protocol (ICMP) echo, (ping) to the available
default routers. Valid entries are off and on. Default setting is on.
ping-time nn
Specifies the time interval of pinging router(s) in seconds. Maximum
number is 42,949,672 (approximately 497 days). Default (minimum) time
is 60 seconds.
network-number XXXXXXXX
The Novell network number for this Model 281xSA hub. The number
must be an eight-digit hexadecimal number.
baud rate 300|1200|2400|9600
The data rate used by the RS-232 out-of-band port. The five values shown
are the only valid entries. If no entry exists in the configuration file, the
default is 9600.