Setting Run-time Parameters
893-743-A
4-47
When Local is selected, the Model 281xSA hub loads the image
file from onboard local flash EPROM. When you set the image
load mode to Local, the boot mode setting is no longer important
(that is, the Model 281xSA hub performs only a local load of the
image file).
c
[Toggle config load mode] Shifts the configuration file load mode
among Remote, Remote w/Local, and Local. The factory default
setting is Remote w/Local.
When Remote is selected, the Model 281xSA hub tries to down-
load the configuration file according to the boot mode specified by
the m command [Toggle boot mode]. The configura-tion file is
never loaded from local flash EPROM, even if downloading fails
and the local configuration file exists.
When Remote w/Local is selected, the Model 281xSA hub tries to
download the configuration file according to the boot mode setting.
The local configuration file is used as a backup in case the remote
download fails. If the download fails, instead of resetting itself and
starting the process over, the Model 281xSA hub loads the
configuration file from local flash EPROM.
When Local is selected, the Model 281xSA hub loads the
configuration file from onboard local flash EPROM. When you set
the configuration load mode to Local, the boot mode setting is no
longer important (that is, the Model 281xSA hub performs only a
local load of the configuration file).
b
[Set boot router’s IP address] Up to 12 numeric characters,
written in dotted-decimal notation. To set this address to [none],
enter 0.0.0.0.
NOTE:
If the local image file is corrupted, you are not allowed to
set the image load mode to Local.