Boot Configuration Menus
893-743-A
4-19
When Local is selected, the Model 281xSA hub loads the image
file from onboard local flash EPROM.
f
[Toggle config file load mode] Shifts the configuration file load
mode among Remote, Local, and Remote w/Local.
When Remote is selected, the configuration file is loaded from the
network via TFTP, as described for command i [Toggle image load
mode].
When Local is selected, the configuration file data is loaded from
NVRAM.
When Remote w/Local is selected, the Model 281xSA hub
attempts to load the configuration file from the network, as
described for the i command [Toggle image load mode]. If the
remote load is not successful, the Model 281xSA hub loads the
configuration file data from NVRAM.
k
[Reset NVRAM to factory defaults] Restores all menu settings
and NVRAM data to the original values set at the factory.
z
[Reset management module] This command causes the Model
281xSA hub to go through the self-test and image loading process.
Before the command takes effect, a confirmation message appears
on the screen.
c
[System configuration menu] Shifts the display to another menu
that allows you to enable or disable RAM tests when the Model
281xSA hub starts up.
NOTE:
When the image load mode is set to Local, local loading of the
image file will not be performed if the Model 281xSA hub has neither an
IPX nor an IP address.
If the local image file is corrupted, you are not allowed to set the image
load mode to Local.
