Avocent DSView 3, Инструкция по установке и эксплуатации

Страница: 59 / 384

Chapter 2: Installation 41
occurs because the DSView 3 software server certificate created when the server is
installed is a self-signed certificate. You may either import the certificate into the DSView
3 software client web browser (choosing to trust the certificate) or obtain a server certifi-
cate from a Certificate Authority (CA) trusted by the web browser.
• To configure the DSView 3 software at a later time, click X (Cancel ) in the top right cor-
ner of the window.
To install the DSView 3 software on a supported Linux or Solaris system:
1. Log in to the server as root.
2. Insert the DSView 3 software CD into your CD-ROM drive. If AutoMount is supported and
enabled, open a command window and continue with step 3.
If your system does not support AutoMount, issue the following command to mount the CD
volume:
mount <device> <mount point> , where <device> and <mount point> are the names
of your server’s CD and mount point, respectively. For example, to mount the first IDE cdrom
on /media/cdrom, enter the command
mount /dev/cdrom /media/cdrom
.
3. Enter the following command to access the readme file:
less /<mount point>/DSView/readme
For example, the following command accesses the readme file on the /media/cdrom
mount point.
less /media/cdrom/DSView/readme
4. Follow the instructions in the readme file.
Configuring the DSView 3 Software
After the DSView 3 software has been installed, it must be configured using a web browser.
During configuration, you specify whether the computer will be a hub server or a spoke server. If
this is your first DSView 3 software server installation,
hub should be selected in the Select
DSView Server Role window. The hub server should be installed before any spoke servers are
added.
What you will need
If the computer will be a hub server, you will need the license key obtained from Avocent and
provide a username and password to use for initial log in.
If the computer will be a spoke server, you will need to identify the associated hub server and
provide the name/password of the hub server’s DSView 3 software administrator.
To configure the DSView 3 software:
1. If you are configuring the DSView 3 software during the installation process, you have already
clicked
Done in the Launch Default Browser window.
If you quit after installing the DSView 3 software installation process (by closing the window),
select
Start - Programs - Avocent DSView 3 - DSView Software .