Avocent DSView 3, Инструкция по установке и эксплуатации

Страница: 148 / 384

130 DSView 3 Software Installer/User Guide
2. Click Appliance Settings in the side navigation bar, then click Ports and then click OSCAR .
The Appliance OSCAR Settings window will open.
3. Click Disable OSCAR Authentication to prevent the supported DSR switch from performing
internal or external authentication. If the Disable OSCAR Authentication checkbox is not
selected, the supported DSR switch will attempt external authentication using the list of
authentication servers that reside in the switch. If the authentication fails, the supported DSR
switch will use its internal user tables.
4. Specify a preemption level for the DSR switch (1-4).
5. The Long Name Display Mode is used when cascade switch or target device names contain
more than 15 characters. Select the radio button to specify whether the OSCAR interface will
display the first 15 characters or the last 15 characters.
6. Click Save and then click Close . The Units View window will open.
To change modem port settings:
NOTE: This procedure is valid for the following managed appliances: DSR1020, 1021, 1022, 1024, 1030, 2020,
2030, 2035, 4020, 4030, 8020, 8030 and 8035 switches.
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the DSR switch name.
2. Click Appliance Settings in the side navigation bar and then click Ports and then click
Modems . The Appliance Modem Settings window will open.
3. Select Modem sessions can preempt digital sessions to enable a modem session to disconnect
an existing Ethernet connection to the DSR switch.
4. Type an authentication time-out for the modem in the range of 30-300 seconds.
5. Type an inactivity time-out for the modem connection in the range of 1-60 minutes.
6. Click Save and then click Close . The Units View window will open.
CCM Appliance NFS and NTP Settings
To display NFS status or change NFS settings for a CCM appliance:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the CCM appliance name.
2. Click Appliance Settings in the side navigation bar and then click NFS . The Appliance NFS
Settings window will open.
3. To enable NFS on the appliance, click the Enable NFS checkbox. To disable NFS, uncheck it.
When you enable NFS, you may also configure the following information:
a. Type an address in the NFS Server field.
b. Type the mount point in the NFS Mount Point field.
c. Select the protocol to be used from the Protocol menu.