Avocent DSView 3, Инструкция по установке и эксплуатации

Страница: 142 / 384

124 DSView 3 Software Installer/User Guide
2. Click Appliance Settings in the side navigation bar and then Versions . The Appliance Version
Information window will open, containing the following information:
• For DS1800 digital switches and DSR switches - application, boot and video FPGA
• For DSR switches (except the DSR4160 switch) - may include application, boot, video
FPGA, matrix FPGA, UART FPGA, digital/application, digital/digitizer, digital/FPGA
and OSCAR FPGA
• For DSI5100 appliances - DSI5100 application and boot versions
• For CPS and CCM appliances - bootstrap and application versions
3. Click Close . The Units View window will open.
Managed Appliance SNMP Settings
NOTE: This procedure is valid for the following managed appliances: DS1800 digital switches, CPS appliances,
CCM appliances and DSR switches.
The SNMP protocol is used to communicate management information between network
management applications and DSView 3 software managed appliances using TCP/IP and IPX
protocols. Other external SNMP managers (such as Tivoli
®
and HP OpenView) may communicate
with your managed appliances by accessing MIB-II (Management Information Base) and the
public portion of the enterprise MIB. MIB-II is a standard MIB that many SNMP target devices
support. The managed appliances will send their traps directly to the external SNMP manager in
addition to sending it to the server.
The following settings appear under SNMP in the side navigation bar:
• System - Enables/disables SNMP. When you enable SNMP, the managed appliance will log
SNMP received messages over UDP (User Datagram Protocol) port 161. UDP port 162 is used
to listen for incoming traps.
• Managers - Stations that can manage the managed appliance.
• Community - Communities to which the traps belong.
• Destinations - Stations that can receive SNMP traps.
• Traps - Available traps and enabled/disabled traps.
The traps must be also configured on each managed appliance using the Command Line Interface
(CLI). The address of the server running the DSView 3 software must be configured as a trap
recipient, the proper community must be set and each desired trap must be enabled.
SNMP traps are logged in the event log file. See Events and Event Logs on page 293. SNMP traps
may also be configured from a system task. See Tasks on page 276.
To change SNMP settings for a managed appliance:
1. In a Units View window containing appliances (see Accessing Units View windows on
page 88), click on the appliance name.