
To perform the AUTO PUNCH:
Once you have entered the punch-in and punch-out locations, and you
have turned AUTO PUNCH mode on, locate to a position within the
sequence which is a few bars before the punch-in point. Then enter
RECORD
mode as usual by pressing PLAY and
RECORD
simultaneously.
However, since the AUTO PUNCH function is on,
RECORD
mode
cannot yet be entered. Instead, the
RECORD
light blinks until the
PUNCH-IN point is reached. When it is reached,
RECORD
mode is
automatically entered and the
RECORD
light stops blinking and stays on
continuously. When the PUNCH-OUT point is reached,
RECORD
mode
is automatically exited and the
RECORD
light goes off, but play continues.
It is also possible to use AUTO PUNCH to automatically enter and exit
OVERDUB
mode. To do this, follow the example given above, but
instead of pressing
RECORD,
press
OVERDUB.
The mode which is
entered is determined by which key is pressed - RECORD or
OVERDUB.
70
Содержание MPC 60
