Adixen ASM 142, Руководство пользователя

Страница: 120 / 336

C 301
Basic internal calibration of the leak
detector
2/5
READY FOR CYCLE
...
...
...
The Leak Detector
is NOT calibrated!
DO YOU WANT TO
USE THE MACHINE?
READY FOR CYCLE !
INLET VENT: off
...
GB
00969
-
E
d
it
io
n
06
-
J
une
08
Internal
calibration with the
internal He calibrated
leak
The internal calibration can be:
• fully automatic:
The internal calibration is automaticaly activated during the start-up
process of the leak detector. It does not require any operator action.
The initial calibration during the start-up sequence allows the unit to
be immediately operationnal.
• on operator request:
An internal calibration can be started by the operator whenever the
leak detector is not in test mode.
If the detector has been calibrated with an external calibrated leak,
the operator should store the values of the internal calibrated leak
B 320.
Tickets If a printer is connected to the leak detector, a ticket is automatically
printed at the end of the calibration: example
2
B 320.
Automatic internal
calibration procedure
Note: Internal auto-calibration set ON, C 302.
• Start the leak detector
Different screens appear during the calibration giving internal
parameters values.
Audio messages inform the operator about internal calibration process
during this one.
When calibration is complete, the
unit is ready to start a cycle.
The digital voice gives to the
operator the message
“Detector ready for cycle”.
Note:
• It is possible to start a test cycle
after a calibration failure: The
operator should confirm the use of a
uncalibrated leak detector.
STDBY
• The test is still possible but “AL“ is displayed
permanently (no value displayed).
The bargraph is always available for the leak
value reading.
LEAK RATE
COR
• Until the autocalibration failure is
resolved, the “!“ is maintained on the
standby screen.