Appendix A – Fieldbus control
425
After the module configuration parameters have been set, the drive control
parameters (see section
Setting the drive control parameters
below) must be
checked and adjusted when necessary.
The new settings will take effect when the drive is powered up the next time, or when
parameter
FBA PAR REFRESH is activated.
–
Displays the fieldbus adapter module mapping file revision stored in the
memory of the drive.
–
Displays the status of the fieldbus adapter module communication.
–
Displays the common program revision of the adapter module.
–
Displays the application program revision of the adapter module.
Note:
In the
User’s Manual
of the fieldbus adapter module, the parameter group number is 1 or A for parameters
TRANSMITTED DATA SELECTION
0
4…6
14…16
101…9999
Defines the data transmitted from drive to fieldbus controller.
Note:
If the selected data is 32 bits long, two parameters are reserved
for the transmission.
…
0
1…3
11…13
1001…9999
Defines the data transmitted from fieldbus controller to drive.
Note:
If the selected data is 32 bits long, two parameters are reserved
for the transmission.
Note:
In the User’s Manual of the fieldbus adapter module, the parameter group number is 2 or B for parameters
…
.
Parameter
Setting for
fieldbus control
Function/Information
Содержание ACSM1 Series
