Zte ZXR10 5900E Series, Configuration Manual

Page: 84 / 226

ZXR10 5900E Series Configuration Guide (IPv6)
Step Command Function
6
ZXR10(config-ospfv3)#
area
< area-id > virtual-link
<
router-id
>[ dead-interval <
seconds
>][ hello-interval
< seconds >][ retransmit-interval < seconds >][ transmit-delay
<
seconds
>]
Defines an OSPF virtual link.
7
ZXR10(config-ospfv3)#
bfd enable Enables BFD function on all
interfaces. Use the no format
of this command to restore the
default value.
8
ZXR10(config-ospfv3)#
default-metric < metric-value > Sets the default metric value
for the OSPFv3 protocol.
This value is allocated to
redistributed routes. The value
range is 1-16777214. The
default value is 20.
9
ZXR10(config-ospfv3)#
distribute-list
{[ access-list
< access-list-name > in ]|[ route-map < name of a route-map >
in
]}
The
distribute-list in
command
filters routes of which the
owner is OSPF routes. The
distribute-list out
command
controls the redistribution
of external routes to OSPF
areas after Type-5 LSAs
are generated. This is a
supplement of the redistribute
command.
10
ZXR10(config-ospfv3)#
maximum-paths < number > Sets the maximum number
of routes for load sharing in
OSPF.
11
ZXR10(config-ospfv3)#
passive-interface
< interface-name > Prohibits OSPFv3-enabled
interfaces from sending
OSPFv3 packets.
12
ZXR10(config-ospfv3)#
redistribute
<
protocol
>[ metric
< metric-value >][ metric-type < type >][ route-map < name >]
Redistributes the routes of
protocols into the OSPFv3
protocol.
13
ZXR10(config-ospfv3)#
summary-prefix
< X:X::X:X/ < 0-
128
>>
Summaries the routes of other
protocols that are redistributed
to OSPF.
14
ZXR10(config-ospfv3)#
timers spf delay
<
delay
>
hold-time < holdtime >
Sets the interval at which the
OPSFv3 protocol computes
routes.
The command parameters in step 2 are described as follows:
7-8
SJ-20150114102049-011|2015-01-15 (R1.0) ZTE Proprietary and Confidential