Zte ZXR10 5900E Series, Configuration Manual

Page: 108 / 226

ZXR10 5900E Series Configuration Guide (IPv6)
When the optional parameter is not carried in the command, the set interval takes effect
for both level-1 hello and level-2 hello on the interface.
For a description of the parameters in Step 3.4, refer to the following table:
Parameter Description
< multiplier > Specifies the IS-ISv6 hello multiplier on an interface. The
value range is 3-1000. The default value is 3.
level-1 | level-2 Specifies the applicable scope of the hello multiplier (level-1
or level-2). By default, the hello multiplier takes effect for both
level-1 and level-2.
When the optional parameter is not carried in the command, the set multiplier takes effect
for both level-1 and level-2.
For a description of the parameters in Step 3.6, refer to the following table:
Parameter Description
< interval > Specifies the interval at which the IS-ISv6 sends PSNP
packets on an interface in the unit of seconds. The value
range is 1-65535. The default value is 3 seconds.
level-1
|
level-2
Specifies the applicable scope of the PSNP interval (level-1
PSNP or level-2 PSNP). By default, the interval takes effect
for both level-1 and level-2.
In general, PSNP is used in point-to-point networks. When the optional parameter is not
carried in the command, the set interval takes effect for both level-1 PSNP and level-2
PSNP on the interface.
For a description of the parameters in Step 3.7, refer to the following table:
Parameter Description
< value > Specifies the metric value of an interface. The value range
is 1-16777215. The set metric value takes effect after the
multi-topology function is enabled. The default value is 10.
level-1
|
level-2
Specifies the applicable scope of the metric value (level-1
or level-2).
The above parameters set the metric value for IS-ISv6 SPF computation on an interface.
When the optional parameter is not carried in the command, the metric-value takes effect
for both level-1 metric and level-2 metric on the interface.
For a description of the parameters in Step 3.8, refer to the following table:
8-12
SJ-20150114102049-011|2015-01-15 (R1.0) ZTE Proprietary and Confidential