ZOLL X Series, Operator'S Manual

Page: 159 / 344

Attaching the Invasive Pressure Transducer
9650-001355-01 Rev. M X Series Operator’s Guide 11-3
Attaching the Invasive Pressure Transducer
Follow these steps when attaching the invasive pressure transducer:
1. Inspect the transducer cable. If the cable shows any signs of wear, breakage, or fraying,
replace the cable. Replace the transducer dome, if necessary.
2.
Apply the transducer according to your organization’s procedures. Always refer the
manufacturer’s Directions for Use before using a transducer.
3.
If the transducer is a disposable unit with a separate cable, connect the transducer to the
transducer cable.
4.
Plug the transducer cable into one of the three six-pin IBP cable connectors on the side of the
X Series unit.
Figure 11-1 Plugging the Transducer into the X Series
When you plug the transducer cable into the unit, the message ZERO PROBE appears in the
numeric display window for that IBP channel.