YOKOGAWA FA-M3V e-RT3 Plus, Hardware Manual

Page: 31 / 274

A1-9
IM 34M06C11-01E
*1: Each number denotes the largest combined number of personal computer link modules, Ethernet interface modules, GP-IB communication
modules (when in slave mode), FL-net interface modules, EtherNet/IP interface module, Modbus interface module and memory card
modules that can be installed. If two or more CPU modules having different maximum limits are installed, the smallest limit applies.
*2: The pulse-capture feature is disabled.
*3: Each number denotes the largest combined number of FA link H modules , FA link H2 modules and fiber-optic FA link H modules that can be
installed. If two or more CPU modules having different maximum limits are installed, the smallest limit applies.
*4: Configure the module using WideField, WideField2, WideField3 or Ladder Diagram Support Program M3.
*5: Each number denotes the largest combined number of fiber-optic FA-bus, fiber-optic FA-bus type 2 and FA-bus type 2 modules that can be
installed in a main unit. If two or more CPU modules having different maximum limits are installed, the smallest limit applies. If subunits are
grouped using fiber-optic FA-bus type 2 modules, the maximum limit may be increased depending on the grouping pattern. For more
information, see the Fiber-optic FA-bus Module and Fiber-optic FA-bus Type 2 Module, FA-bus Type 2 Module (IM 34M06H45-01E).
*6: FA link H, fiber-optic FA link H, fiber-optic FA-bus type 2 and FA-bus type 2 modules must be used with sequence CPU modules version 8 or
later. For information on the version of a sequence CPU module, refer to the mark on its side. There is no usage limitation, however, for
F3SP
 -  S.
*7: The maximum number of each module that can be installed depends on the operating mode. The left number and right number in each cell
apply when the module is in master mode and slave mode respectively.
*8: Up to 7 modules can be installed if used with FL-net (OPCN-2) interface module or EtherNet/IP interface module, provided link device
capacities are not exceeded.
*9: FL-net (OPCN-2) interface module can be used with sequence CPU modules rev. 5 or higher. There is no restriction when used with
F3SP

-

S modules.
*10: FA link, FA link H ,FA link H2 and fiber-optic FA link H modules cannot coexist with F3SP7  -  N.
*11: Available only for REV: 02: □□ or later of the FA link H2 module. The FA link H2 module can only be used with F3SP
 -  S.