YOKOGAWA FA-M3V e-RT3 Plus, Hardware Manual

Page: 109 / 274

A2-75
IM 34M06C11-01E
(26) F3YD32-1T TTL Output Module
Item Specifications Item Specifications
Output type
Transistor contact
(TTL output) Fuse None
Output
voltage
Off time
4.9V min. (no load)
3.0V min. (with 0.4mA load) Number of points 32
Common line type 8 points/common On time
0.4V max. (over entire load
range)
Isolation method Photocoupler isolation
Response
time
OFF
→
ON 1ms max.
Withstanding voltage
1500V AC for one minute
between the group of
terminals for external
connection and the
internal circuit
ON → OFF 1ms max.
Rated load voltage
DC 5V DC
AC
─
Dissipating current 210mA (5V DC)
Operating load voltage
range
4.5 to 5.5V DC Output display
*2
LED (Lit when output is on)
Output
current
Off time 0.4mA/point (source)
Output status when the
program stops
HOLD/RESET
*3
When a sequence CPU
module is used:
Default: RESET
Can be set globally on a
module-by-module basis
*4
On time 16mA/point (sink)
When a BASIC CPU module
is used:
No setting function
The status is always HOLD
Maximum load current
16mA/point
128mA/common line
External power supply 5V DC, 60mA
External connection One 40-pin connector
Surge protector
*1
Zener diode Weight 110g
*1: If an inductive load, such as a relay, is to be connected, a surge protector is also required on the load side. Connect
a surge protector or a diode across the load nearby so that the module output terminal voltage will not exceed the
specified operating load voltage range. For details, see Subsection A3.6.5, “Connecting Output Devices.”
*2: The contact operation of the output block of the circuit and the LED display operate independently and thus may be
inconsistent in the event of an error.
*3: For information on the module’s behavior during a CPU failure, see subsection A4.3.3, “Indicating Problem Severity
and Status of Output Module.”
*4: When F3SP22, F3SP28, F3SP38, F3SP53, F3SP58, F3SP59, F3SP66, F3SP67, F3SP71 or F3SP76 module is
used, this setting can be specified in 16-point units.