YOKOGAWA FA-M3V e-RT3 Plus, Hardware Manual

Page: 131 / 274

A2-97
IM 34M06C11-01E
A2.7 Cables
CAUTION
Be sure to hold the cable’s connector when connecting or disconnecting the cable. The
cable may break if you pull it forcibly while holding any part other than the connector or if
you apply stress to the cable joint when the cable is bent at an angle of almost 90° from
the connector.
Front of CPU module
FA020705.VSD
(1) Cables for Programming Tool
The programming tool cable is used to connect CPU modules, such as sequence CPU
modules, to external equipment such as a personal computer or a display unit.
Connect the cable to the connector labeled PROGRAMMER on the CPU module’s front.
Note
This cable cannot be used with the F3SP66-4S, F3SP67-6S, F3SP71 or F3SP76
sequence CPU module.
 KM11-2N (for PC9801 (NEC))
Model Length L (m)
Tole
(cm)
Tolerance –f
(cm)
Maximum number of
insertions
Equipment
end
CPU module
end
KM11-2
N
3 20 0 500 times 1000 times
1
2
5
6
1
2
3
4
5
7
8
SHIELD
To CPU module
SD
RD
SG
SG
FG
SD
RD
RS
CS
SG
CD
Pin No.
Signal name
To CPU
module
FA020701.VSD
To external equipment
Signal name Pin No.
To external
equipment
25-pin male D-sub
External View Internal Connection