YOKOGAWA FA-M3V e-RT3 Plus, Hardware Manual

Page: 265 / 274

C2-7
IM 34M06C11-01E

Output Block
Item
Specifications
F3WD32-3F
Output type Transistor contact (sink type)
Number of points 16
Common line type 8 points/common
Isolation method Photocoupler isolation
Rated load voltage
(Operating load
voltage range)
DC
24V DC
(20.4 to 26.4V DC)
AC ───
Maximum load current 0.1A/point, 0.4A/common line
Response time
OFF→ON 1ms max.
ON→OFF 1ms max.
ON voltage 0.5V DC max.
Off-time lead current 0.1mA max.
Service life
Mechanical ───
Electrical ───
Surge protector *1 Zener diode
Fuse None
Dissipating current 100mA (5V DC) (including the input block)
Output display *2
LED (Lit when inputs are turned on)
If the selector switch is set to OUT, the output state is displayed.
Output status when the program
stops HOLD/RESET *3
When a sequence CPU module is used:
Default: RESET
Can be set globally on a module-by-module basis.
When a BASIC CPU module is used:
No setting function
The status is always HOLD
External power supply 24V DC, 30mA
External connection One 40-pin connector (shared with the input block)
Weight 100g (including the input block)
*1: A surge protector is also required on the load side if an inductive load such as a relay is to be connected. See
subsection A3.6.5, “Connecting to Output Devices.”
*2: The contact operation of the output block of the circuit and the LED display operate independently and thus may be
inconsistent in the event of an error.
*3: For information on the module’s behavior during a CPU failure, see subsection A4.3.3, “Indicating Problem Severity
and Status of Output Module.”