YOKOGAWA FA-M3V e-RT3 Plus, Hardware Manual

Page: 115 / 274

A2-81
IM 34M06C11-01E
(29) F3YD64-1M Transistor Output Module
Item Specifications Item Specifications
Output type
Transistor contact
(matrix scan)
Service life
Mechanical
─
Electrical ─
Number of points 64 Surge protector Zener diode
Common line type 8
×
8 matrix Fuse None
Isolation method Photocoupler isolation Dissipating current 125mA (5V DC)
Withstanding voltage
1500V AC for one
minute between the
group of terminals for
external connection
and the internal circuit
Output display *1
LED (Lit when output is on)
Status displayed for 32 points
selected by a switch
Rated load voltage
(Operating load
voltage range)
DC 12-24V DC
(10.2 to 26.4V DC)
AC ─
Output status when the
program stops
HOLD/RESET
*2
When a sequence CPU
module is used:
Default: RESET
Can be set globally on a
module-by-module basis. *3
Maximum load current 0.1A
When a BASIC CPU module is
used:
No setting function
The status is always HOLD
Response
time
OFF
→
ON 16ms max.
ON
→
OFF 16ms max. External power supply 12-24V DC, 40mA
ON voltage 1.5V DC max. External connection One 40-pin connector
Off-time leak current 0.1mA max. Weight 110g
*: The F3YD64-1M module is designed to drive an 8

8 matrix of LEDs and cannot be used for loads other than LEDs.
*: No resistor for limiting load current is included in the module. Add current-limiting resistors to the DATA1 to DATA8
lines before connecting the load to the module. Any LED display whose LED components are equipped with a
current-limiting resistor cannot be used as the load.
*: Use the output terminals in units of 8-terminal groups classified as Y0001-Y0008, Y0009-Y0016, Y0017-Y0024,
Y0025-Y0032, Y0033-Y0040, Y0041-Y0048, Y0049-Y0056 and Y0057-Y0064. If there are any output terminals in
the same group to which no load is connected, connect a diode to that terminal. For the diode, select one that has
the reverse voltage rating (VR) of at least 30V and an average rectified current rating (IO) of at least 0.3A. There is
no need to connect diodes to a group where no load is connected at all.
*1: The contact operation of the output block of the circuit and the LED display operate independently and thus may be
inconsistent in the event of an error.
*2: For information on the module’s behavior during a CPU failure, see subsection A4.3.3, “Indicating Problem Severity
and Status of Output Module.”
*3: When F3SP22, F3SP28, F3SP38, F3SP53, F3SP58, F3SP59, F3SP66, F3SP67, F3SP71 or F3SP76 module is
used, this setting can be specified in 16-point units.