YOKOGAWA FA-M3V e-RT3 Plus, Hardware Manual

Page: 50 / 274

A2-16
IM 34M06C11-01E

Terminal dimensions
F3PU30-0N F3PU30-0S
FA020306.VSD
7.1mm
8.2mm
M3.5
7.1mm
8.2mm
M4

Adaptable crimp-on terminals
Vendor Model Compatible Conductor
Crimping Torque
F3PU30-0N F3PU30-0S
Japan Solderless
Terminal Mfg Co., Ltd.
V1.25-M3
AWG22 to 18
(0.33 to 0.82mm
2
)
(Copper wire) 0.8N

m
(7.1 lbf

in)
May not be
used
Nippon Tanshi Co., Ltd. RAV1.25-3.5
Japan Solderless
Terminal Mfg Co., Ltd.
V1.25-M4
1.2N

m
(10.6 lbf

in)
Japan Solderless
Terminal Mfg Co., Ltd.
V2-M4
AWG16 to 14
(1.3 to 2.1mm 2 )
(Copper wire)
Note
When crimping terminals, be sure only to use the tool specified by each terminal
manufacturer.
Once the power supply module is installed in the base module, both the FG terminal of
the power supply module and the signal ground (GND terminal of the module’s 5V
output) of the FA-M3 automatically come into contact with the metal chassis of the base
module. The FG terminal and the signal ground are isolated from each other inside the
power supply module.
For details on the grounding lines of the FA-M3, see subsection A3.3.2, “Grounding
Lines.”
Note
- F3PU30-0S module is the same as F3PU30-0N module, but it uses M4 terminal
screws instead of M3.5 terminal screws. Other than terminal screw diameter, their
dimensions and internal circuitries are identical.
- F3PU30-0N is not CE Marking compliant.
F3PU30-0S is CE Marking compliant.
- For compliance to CE Marking of the final product incorporating these modules,
F3PU30-0S must be used.
Note
Power supply circuit which is connected to FAIL signal contact output terminal must be
SELV and limited-energy circuit separated by reinforced insulation or double insulation
from hazardous voltage.