6/98
High Capacity Feeder Option
12-18
Xerox DocuPrint N17 Service Manual
12.3.8 Elevator Belt (Front)
Removal
1. Open the feeder drawer and remove all paper.
2. Disconnect the AC Power Cord from the High Capacity Feeder.
3. Remove the four screws that secure the Rear Access Cover. Remove the access cover.
4. Disconnect J5, J7, and J9 and slide the drawer fully open.
5. Release the latches on the drawer rails and remove the drawer from the cabinet (Figure 12.3.8.1).
6. Place the drawer on a suitable work surface.
7. Remove the six screws securing the drawer Front Cover (Figure 12.3.8.1).
8. Remove the screw and clamp from the belt drive clamp (Figure 12.3.8.1).
9. Remove the upper Gear retaining clip (Figure 12.3.8.1).
10. Slide upper Gear and Belt off the upper shaft (Figure 12.3.8.1).
11. Remove Belt.
Figure 12.3.8.1 Elevator Belt (Front)
Replacement
1. Perform the removal steps in reverse order, but do not replace the elevator assembly in the cabinet
until the Belt Adjustment check is performed.
2. Check the Belt Adjustment.
5
5
7 (6 places)
8
9
10
rep_09
www.printcopy.info
www.printcopy.info
