![background image](http://html1.mh-extra.com/html/xerox/docuprint-n17/docuprint-n17_service-manual_4131577269.webp)
6/98
Xerox DocuPrint N17 Service Manual
7-19
Repair Analysis Procedures (RAPs)
NOTE: Remove Tray 1 and perform a visual inspection while inserting the Tray Assembly into the slot.
NOTE: Refer to Sheet Size Selection for switch combinations for various sheet sizes.
8 The Mid Roll Assembly has normal rotation.
NOTE: This can be inspected while performing the Diagnostic Mode 1, Exit Motor.
Y:
Go to step 9.
N:
Go to step 10.
9 The Exit Roll Assembly is rotating normally.
Y:
Go to step 11.
N:
Go to step 12.
10 There is +24VDC between the following pins:
•
P/J24-1 and P/J24-3
•
P/J24-2 and P/J24-4
Y:
Replace the Exit Step Motor Assembly.
N:
Replace the Print Engine Controller.
11 Ensure the Stack Full Actuator uncovers the Stack Full Sensor when it detects the presence of a
sheet and covers it when no sheet is present.
Y:
Go to step 12.
N:
Replace the Stack Full Actuator or the Stack Full Sensor.
NOTE: This can be inspected by performing the Diagnostic Mode 1, Sensor Input Test.
12 Ensure the Rear Cover Assembly is functioning properly.
Y:
Replace the Print Engine Controller.
N:
Replace the Rear Cover Assembly.
www.printcopy.info
www.printcopy.info