6/98
Xerox DocuPrint N17 Service Manual
8-33
500-Sheet Paper Feeder Option
8.8 How to Perform Troubleshooting
8.7.2 Wiring Schematic in this section for the 500 Sheet Paper Feeder wiring diagram.
8.9 RAPs
8.9.1 Tray 2/3 Failure (E11)
1 There is +5VDC between P216-5 and P216-6.
Y: Go to step 4.
N: Go to step 2.
2 There is +5VDC between J200-5 and J200-6.
Y: Replace the Deck 2 Harness Assembly.
N: Go to step 3.
3 There is +5VDC between P/J22-6 and P/J22-7.
Y: Replace the Tray Harness Assembly.
N: Go to
RAP 7.4.5 Low Voltage Power Supply (LVPS) Assembly Failure (+5VDC).
4 There is +5VDC between P220-5 and P200-6.
Y: Go to step 5.
N: Replace the Deck 3 Harness Assembly.
5 There is voltage between P/J22-4 and P/J22-7 and between P/J22-5 and P/J22-7 in the range of
1.9VDC to 3.6VCD.
NOTE: Measure voltage with paper loaded into the paper tray and the tray inserted into the paper deck.
Second set of voltages are present only when Deck 2 is installed.
Y: Replace the Print Engine Controller.
N: Go to step 6.
6 There is voltage between P/J200-3 and P/J200-6 and between P/J200-4 and P/J200-6 in the
range of 1.9VDC to 3.6VCD.
NOTE: Measure voltage with paper loaded into the paper tray and the tray inserted into the paper deck.
Second set of voltages are present only when Deck 2 is installed.
Y: Replace the 500 Tray Harness Assembly.
N: Go to step 7.
www.printcopy.info
www.printcopy.info