6/98
Xerox DocuPrint N17 Service Manual
4-25
Repair/Adjustment Procedures
4.6.2 Inlet Chute Assembly
Removal
1 Remove the Paper Handling Unit Assembly (
REP 4.5.1 Paper Handling Unit Assembly).
2 Free the Toner Sensor wire harness from the Inlet Chute Assembly.
3 Remove the two screws securing the Inlet Chute Assembly. (The screw on the right was already
removed in step 1.)
4 Bias the Inlet Chute Assembly towards the right and slightly towards the rear in order to clear the
bosses at the left side of the Chute Assembly. Lift upward and remove the assembly.
Figure 4.6.2.1 Inlet Chute Assembly Removal
Replacement
Perform the removal steps in reverse order.
SAS420F.CDR
sas420fa
www.printcopy.info
www.printcopy.info