26
Hint:
Before connecting on serial
port, it is useful to check the
Serial Port
tab according to the
description
a.)
shortly when the device will readout the value IMEI, IP data. Afterall you can split the
connection with the
Close
, then
at the
TCP-IP
tab you can connect with the readout data filling to
the
Device IP
and
GPRS Login
fields.
After the successful connection
…
When connecting, the signal strength diagram and status piktograms will be grey for a short time. This
means that currently there are no available status
and signal strength values.
Later the
PIN/GSM/GPRS status
and
signal (CSQ
)
values will be visible by colours.
During this time, the device transmits the life
signals and signal strength values frequently,
according to the settings. The currently used
cellular network connection is also listed (e.g. as
3G).
When connecting to the GSM network or the mobile network, the device checks the entered PIN code
and indicates that it was accepter
–
and the entered password, if was any. (In case of a SIM PIN error,
the device will restart the module.)
In case of an error, see Chapter 9.
Attention
! In case of using TCP connect, the program automatically disconnects the device after 15
minutes of inactivity.
4.3 Status info and device data
In the
Status window
(2) displays device identification information such as
IMEI
(GSM modem ID),
ICC
(SIM card ID),
HW ID
(unique hardware identifier of the device),
SW VER
(firmware version),
IP ADDR
. (modem IP address on the network).
On the right side of the window, below the CSQ (field strength value and graphical status), three more
statuses are displayed:
