86
OUTOF
vagy
OUTOFF
Gate closing
If set to bistable mode: Relay contact opens
When set to monostable mode: Stops the timer
7.4 Examples for SMS command parameters
According to the SMS text message format standard, in one SMS message command you can
use max. 158 characters in once SMS command.
When the required parameters are not able to fit in one message, you can start a new SMS
commad message by using the
PW=
password authentication at
first, then you can continue
it with the next parameter or command.
During the parametring you have to use password authentication in every message first
position, and the
RESET
command in the last message
’
s last position (once only).
The command messages can be sent one after, then the device will get these and processing
them in a time order sequence.
Take consider that the device will be restarted when receiving the
RESET
command. the
parameter receiving and restarting the device cuold requre minutes until the configuration will
be finished. Always wait while the device is be ready for the usage and signaling of the
incoming events.
The parametrisation can be performed due to the parameter names and values which have
been described in the Chapter 5 and Chapter 6.
You can found some
examples for some parametring SMS messages
for each operation
mode of the device
–
which can be seen in the following:
1.
GSM signaling/transmitting (pre-configured for this operation mode by
general)
The alarm system is connected to the TIP-RING input port, the received Contact ID codes are
forwarded through the GSM network and signaling to the remote dispatcher centre.
