32
If you wouldn’t like to send all listed
parameter to the device then push to the
Deselect all
and mark only the required parameters on the parameter groups which you are attempt to
sended. Then push the
Write config
button. Only the selected parameters will be sent.
Further detailed parameter description can be found in the Chapter nr. 5.
4.6 Restarting the device
To restart Easy2S
,
click the
Restart device
button at the bottom right of the screen.
The device will then issue the
RESET
command -
which you can also see in the Terminal window (3)
- and the field strength and status values will be
grayed out and the message
Restart device
will
be displayed.
The device restarts and then reconnects to the
port used at the end of the process. As soon as it
becomes available, the status and field strength
values are updated - the LED states change to
color again.
4.7 Reload of factory settings
If you have to clear (reset) the device, click the
Factory reset
button at the bottom right of the screen,
and then click
Yes
to confirm.
The device will then run for approx. it restarts after half a minute, which will be indicated by the
ERASECONF
message then the
^SHUTDOWN
message in the terminal window, and the
Status
and field strength values are also grayed out.
