38
Check that the
GPRSEN
value is
Disabled
, which means that the device operating as a GSM
transmitter. The
SYS1
value equals the phone number of the dispatcher centre.
You can modify the
ACCOUNT
parameter value if you are attempted to signaling an own
customer ID for the identification.
The
LFGSMFREQ
is the life signal sending frequency on GSM channel, which is setup to 60
seconds by general. Check that it is fine or not.
If
you’ve changed
one of the listed parameter values, then the program will highlight the
changed value lines by
bold
. For sending the listed parameter values for the device (regarding
the
Selected
coloumn)
–
check the proper selection
–
push the
Write config
button at the
bottom of the screen. At the end of the parameter sending, the device is restarting by using
the new settings.
Then, open the
Other
parameter group and the program will load the related parameters.
Check that the
DTMFTIME
80 seconds value is proper for applying a pause between the
TIP-RING Contact ID signals.
